Skip to main content
Swing Bench Dual-Monitor Launch Data Fitting COEUR D'ALENE, ID • Fitting Since 2013
Session Menu / Driver

Driver Sessions

No club swings distance results around more than the driver, and it's still the one most golfers buy straight off a rack. A driver session backed by two independent monitors is usually the single biggest carry-and-dispersion gain available in one visit.

What We Capture

Every Swing, Logged Twice and Compared

A radar unit and a camera unit record ball speed, launch angle, spin rate, spin axis, smash factor, and attack angle on every swing — your current driver and every demo head off the wall, side by side, in the same session.

Then we watch how the two units agree on the shortlisted heads across a full round of swings. Two drivers can post nearly identical numbers on a center hit and behave completely differently on the mishits that actually happen on the course — agreement across both monitors is what tells us a pattern is real.

Driver Session Data Points
Ball Speedmph
Launch Angledegrees
Spin Raterpm
Spin Axisdegrees L/R
Attack Angledegrees
Cross-Unit Agreement%
The Variables

What Actually Changes in a Driver Session

Loft & Face Angle

Adjustable hosels let us dial loft in half-degree steps. A negative attack angle usually calls for more static loft than the number stamped on the sole suggests.

Shaft Weight & Flex

Shaft weight shapes swing timing more than the flex letter alone does. We test across weight classes to find whichever combination produces the most repeatable strike location.

Head Design

Face flex, perimeter weighting, and moveable weight ports each shift launch and forgiveness independently — tested against your actual mishit pattern, not a spec sheet claim.

Length

A shorter, better-controlled driver frequently beats a longer one on center-strike percentage, which tends to outweigh a few extra theoretical yards.

Center of Gravity

CG placement shapes launch and spin somewhat independently of loft. A low-back CG head generally raises launch while trimming spin for players chasing carry.

Grip Size

An oversized or undersized grip changes hand action through impact, which can quietly shift face angle at contact. Grip size gets checked on every driver session.

Common Misses

What a Driver Session Usually Fixes

The Slice

A left-to-right spin axis tilt is usually rooted in face-to-path timing, but the right shaft and loft combination can meaningfully reduce curvature while you work on swing mechanics.

Low, Diving Ball Flight

Insufficient launch and spin for your attack angle causes shots to fall out of the air early. Adjusting static loft and CG placement typically corrects this without touching swing speed.

Ballooning in the Wind

Excess spin sends shots high and back, costing carry and exposing the ball to crosswinds. A lower-spin head or shaft, sometimes paired with reduced loft, flattens the flight.

Strikes Scattered Across the Face

If your dispersion pattern shows contact spread widely across the face, a more forgiving head paired with correct length and lie can shrink that pattern noticeably.

Find Your Driver Setup

Sessions run 60 to 75 minutes with your current driver plus demo heads across major manufacturers. You'll leave with a printed report and, if you choose, a build order.